Some proposals simply say to paint the walls and ceiling and never specify the number of coats to be applied. If the colors are similar enough, it's possible to get away with one coat of paint and not discount your pricing. No matter how hard you try, tiny, pin-sized air holes will pop exposing the original walls. This may not bother you if you can't notice it, but principally speaking you should have paid your painter less for the work.
Small random-orbit or pad sanders make this job go faster. (Wallis first covers these boundaries with Synkoloid patching compound so no edge is visible after sanding.) As shown, you want to make sure that there is a feathered, smooth transition from exposed wood to old paint. For areas that might get close scrutiny, you can follow up with a 100- or 120-grit rubdown to erase any scratches.
Dennis Gleason is a Certified Professional Estimator (CPE), accredited by the American Society of Professional Estimators. He is a painting business veteran with more than 20 years' experience and has been a guest lecturer in construction classes at San Diego State University, sponsored by the Associated General Contractors. He has also taught and coordinated construction cost estimating classes for the Associated Builders and Contractors. He holds a BS degree and a certificate in construction practices (sponsored by the Associated General Contractors), both from San Diego State University.

It is important to know the distinction between finishes. Flat finishes have a soft, velvety appearance that will not highlight minor bumps and gouges as would glossy coats. There are many pros to flat finishes; however, it is virtually impossible to clean. Satin finishes have a low shine with minor reflective qualities. Again, satin has its perks; however, it is a lot harder to apply because it shows imperfect textures. Any professional painter will be able to go into full detail about the pros and cons for each finish and which is a better choice for your home.


Not only careful communication is essential, but we would greatly recommend, when you pick out your type and brand of paint that you go and pay for it, with the contractor's discount, which is given by Sherwin-Williams and most paint companies. Then you will know how much paint you purchased and the coverage. If it is possible, inspect the work of the painter daily.
Simple costing techniques, tips on how to survive up against the competition, the big companies with several crews and foremen employed. I don't ever aspire to be that kind of contractor. This is a fresh viewpoint and it gave me so much I am no longer looking for a painter's contracting manual. I found a lot of his times for painting different items to closely match my own.
Get the right sheen: A coating’s ability to reflect light ranges from high gloss, the shiniest and most washable, to flat or matte, which has no luster and is tough to clean. High gloss is unforgiving to apply—every brushstroke is visible—so Henrique uses semigloss for trim, windows, and doors. Satin has a bit less luster and plenty of durability, making it a great choice for cabinetry. Low-sheen eggshell is Henrique’s pick for walls. Flats and mattes, while great at hiding imperfections, are more easily stained, scratched, and dinged; they’re best on ceilings.

interior painters


Create a shortlist, then get three or more references — contact information for previous customers — from each contender. Ask these references how long ago they hired the contractor in question; if it’s been several years, they can evaluate how well the paint job has held up. If you go so far as to inspect the work in person, pay attention to the windows, doors, and trim. These are areas where careful technique goes a long way, and where carelessness is especially evident.
Keeping water vapor out of a house’s outer walls is easier if there are plastic vapor barriers between the drywall or plaster and the framing. This is less often the case in older homes than in newer ones. If peeling occurs near or in a bathroom, shower-related dampness is likely at fault. One way to reduce the area’s moisture level is to put in an exhaust fan. In general, if part of the house is consistently damp, then the origin of that dampness must be discovered and dealt with.
Even the best exterior paint can fail if it's applied incorrectly. Always use a primer when painting any untreated surface to seal it off and to provide a base for topcoats to stick to. Alkyd primers are best for bare wood because they cover bleed-through from wood knots better; be sure the label states that the primer is designed to stop bleed-through. Water-based primers are a good choice if knots aren't an issue. Water-based paints are compatible with both types of primer. When repainting, prime only when necessary. If the paint hasn't cracked or flaked, you may not need to prime at all. Advantage 900 from Porter Paints is designed to go over any existing paint without priming or sanding. If you must scrape down to bare wood, spot-prime. Not sure whether priming is needed? Try this test: Paint a small portion of the wall and let it dry. Then put an adhesive bandage on the newly painted surface and snap it off. If paint sticks to it, the old paint won't support a new coat and requires a coat of primer. If the bandage is clean, power wash the siding and paint. For painting new construction, the FPL recommends dipping each piece of siding in a paintable water repellent, priming, then applying two coats of water-based paint. The lab also suggests installing siding on furring strips, creating a ventilated space behind it to reduce vapor. Seal the bottom with screening to keep insects out. If you hire a painting contractor, be sure he or she follows the paint manufacturer's directions. For example, the temperature should be between 50° and 90°F to apply water-based paint. Also, the topcoat should go on within two weeks of the primer. If you wait too long, the mechanical bond between the two won't be as strong because the surface texture of the primer breaks down. And if two topcoats are used (recommended for new construction), the second should go on within two weeks of the first. There are lots of exterior paints out there. Knowing how to pick the best from a lineup of look-alike cans will help your paint job last well into the next century.

When the primer is dry, caulk all small joints (less than ¼-inch-wide) in the siding and trim. Most pros use siliconized acrylics—paint won't stick to straight silicones—but Guertin and O'Neil like the new, more expensive urethane acrylics for their greater flexibility and longevity. O'Neil stresses that it's shortsighted to skimp on caulk. "If the joint fails, you're back to square one." Guertin uses the lifetime rating as his quality guide. "I don't expect 35-year caulk will last 35 years, but it should last longer than a 15-year caulk."


Dedicated to developing long-lasting relationships with our customers, our skilled commercial painters always strive to give you the quality you expect in a timeline that’s unexpected. At Genesis Total Exteriors, our customers never have to worry about poor workmanship or property damage. Our expert commercial painters have a ton of experience in providing interior and exterior painting services to all types of businesses, including:

house outside painting


I managed commercial construction projects for many years, have built and remodeled several properties, and never once have I encountered any of these scams. The tone of this article is deeply troubling. The author seems to be saying that ALL painting contractors are inherently dishonest, and that has not been my experience. The underlying advice here is sound: get it all in writing and cover as many contingencies as possible--so pointing out potential pitfalls like coat coverage is helpful. But do that in the spirit of clear communication of expectations, not with the expectation that the person you are hiring will try to cheat you at every turn. Not every contractor takes outrageous advantage of change orders; not every contractor will sneak past necessary preparation and/or repairs. Contractors of all sorts get a bad rap as it is; reinforcing a stereotype with articles written from this point of view just seems unproductive.
John Harkey Jr. the owner was called home after college to take over his fathers Paint Business, shortly after John ramped up the business from just paint and handyman to full-service remodeling and commercial development. For 17 years he has remodeled hundreds of homes, built multifamily residences as a general contractor and project manager for multiple developers, and for the last 10 years, in addition, he has been an active real estate agent and home developer for himself. John just understands all aspects of real estate.
If a company has a formal training program, it’s a safe bet that they have their act together. They can do training in-house through regular meetings of their employees.  They can have field training systems in place, usually coordinated with classroom training sessions.  They can also use trade associations, such as PDCA (Painting and Decorating Contractors of America) or paint manufacturer’s representatives to stay up to date with the latest materials and techniques. 

house painters in my area


Paint will be your next-biggest cost, at anywhere from $20 to $70 or more per gallon, depending on the sheen, the grade you’ve chosen and any special features. Some paints, for instance, are mold resistant. Others suppress smells or require fewer coats. Some have a lifetime warranty. Paints with warranties, however, may not be worth a higher price. In Consumer Reports tests approximating nine years of wear, only a few exterior paints and stains with lifetime warranties held up well. But “you’ll grow tired of the color long before a good-quality paint wears out,” Bancroft says.
A true professional should be able to supply you with a list of previous work and happy customers. Speaking with a previous customer will help you get insight on how your potential contractor works on the job, stays close to deadlines and keeps you up-to-date on your home painting project. Be slightly skeptical if he or she only has a small number of homeowners who are available to speak with, as they could be relatives or friends.

interior painters near me


The Evolution System uses a 100% solids polyurea with unique technology that offers extreme adhesion, rapid cure, and maximum broadcast times. The vinyl flakes come in a variety of blends to mix and match with your choice of basecoat colors. This is one of the most popular systems for because of its wide variety of applications. Walk on in 4 hours & drive on in 24 hours.
We are a Naperville-based house painting company offering professional, high quality painting -for interior painting, exterior painting, & deck staining, & powerwashing - without the high prices.  Each project is closely monitored by the owner, from the paint and color selection through to the last stroke of the brush.  We provide "one client at a time" service.

house painter near me

×