so what about hardwood chamfer boards? Specially the common post war 60-70mm chamfer boards. The old paint peels, so the painter sanded it back to bare timber, primed it with water based timber primer,and finished with exterior paint. After about 1 month, the paint had bubbled where the sun hits it most. The painter was advised to use an oil based primer, and the same thing happened. Talking with other painters, they said this is a common issue, and it is not a paint issue, it’s more to do with the timber.
exterior painters near me
High percentage of solids. The solids are what's left on the wall after the paint has dried. Anything over 45 percent is considered good; the higher the level of solids, the better, because you'll wind up with a denser, more durable coating. For example, a gallon of Dulux Exterior Flat contains 52 percent solids by weight. However, be aware that some companies add cheap fillers to beef up the percentage of solids - that makes it wise to stay away from inexpensive paints with a high level of solids. Although you typically won't find information about solids on the label, check with your paint retailer, ask to see product data sheets or fire up your modem and check the company's Website.
Satin - Has a slight sheen as seen in Figure 6. This is our standard paint sheen unless specified otherwise. Satin is more durable and easier to clean than a Flat paint. It may highlight rotted or swollen areas in the siding more than a Flat paint. Scott's Painting & Staining Inc. can repair these areas prior to repainting. The house in Figure 6 is finished with Sherwin Williams SuperPaint in a Satin finish, which gives the house a brilliant sheen!