I've seen this article sent out 4 times now. It's out dated in terms of today's "Scams." Paint stores haven't charged more money for deeper paint colors in over 15 years. Also Water downed paint? Seriously? That would never happen in the real world. And Wall repair? what painter would ever not assume wall repair as included? This article is a waste of time and should be taken down or edited to reflect actual scams of todays times.
What is color? Color or colour can be defined as the “visual perceptual property corresponding in humans to the categories called red, green, blue and others.” In other words, color is really what the eye perceives. Color is created by the spectrum of light – which is the distribution of light power vs. wavelength – combining with the spectral sensitivities of the light receptors in the eye. We associate color categories and color’s physical specifications with materials, objects, and light sources; this is based on the color’s physical property, i.e., reflection, light absorption, or emission spectra. The emission spectra of a chemical element or compound is defined by the frequencies at which the element’s or compound’s atoms are emitted when returned to a lower energy rate. When a color space is defined, colors can thus be recognized numerically by their coordinates. Read The Six Colors of the Eiffel Tower
Inspect the surface area for holes, cracks or other problems and apply acrylic caulk to fill them in. Use a putty knife to smooth out the caulk and remove any excess to prevent bumps. For particularly thin or narrow crevices, you may have to use your finger to smooth out the caulk. Caulk contracts and shrinks, so apply a second layer once it's dried.
O'Neil patches shallow holes and divots with Ready Patch because it dries fast, sands smooth, and stays flexible. Deep cracks and rotten spots are best repaired with two-step epoxies, such as those made by Advanced Repair Technology. (For a step-by-step instructions, see Repairing Rot with Epoxy.) The days of using polyester auto-body fillers on wood are over. "They cure too hard," says Portland, Oregon–based painting contractor Kathleen George. "They look good at first, but then they peel away."
Courtney and his guys did a wonderful job on our house. We had the entire exterior painted, which also included a lot of prep work because of all of the wood repair needed. We got several quotes, but Courtney's stood out as it was thorough with great attention to detail. They were on time each day, friendly and courteous. Courtney was also very responsive when we had questions arise. We will be using them again to paint the interior of the house. I would highly recommend A Touch of Color!
Lap marks are those ugly stripes caused by uneven layers of paint buildup. They occur when you roll over paint that’s already partly dry. (In warm, dry conditions, latex paint can begin to stiffen in less than a minute!) The key to avoiding lap marks when doing DIY wall painting is to maintain a “wet edge,” so each stroke of your roller overlaps the previous stroke before the paint can begin to dry.
This company has done a outstanding job on my company website - Mr. Epoxy & Paint and the service has been unreal. I purchased a add on service I was confused about and to no fault of there own they refunded my money for the add on service. In business nowadays it’s hard to get what you pay for let alone customer service like this and a company that goes the extra mile. I’m literally blown away this company keeps there word and does more than they promise. Thanks for everything Footbridge !!
When I had my interior painting done, after clearing out all of the furniture, myself, I also removed all of the wall plates in all the rooms to be painted. They were a beige color and probably yellowed. The wall was originally an off white and I had it painted a light-mid grey, so those wall plates would look terrible. After pricing replacement plates, switches and outlets (Would have been way too expensive to replace all of them), I decided to just paint all of the wall plates, switches and outlets (Used just a black gloss spray paint). I sprayed the plates outside and used a small brush on the switches and outlets. It worked out just fine and the blacks plates, etc compliment the wall color. It has been 7 years and the plates, switches, outlets are holding up well.
Project management is important for contracted painting jobs because it helps with communication and lowers the chance of complaints. The fact is, contracting is the #1 source of consumer complaints in the state and project management is what triggers most calls to the State Contractor’s License Board and the Better Business Bureau. With a proper project management system in place, these complaints can be avoided and your job will be completed the right way.
You are right on with this - why do people leave switch plates on when it's just so easy to take them off? Another thing that happened to us - we had the popcorn ceiling taken off and the ceiling painted white. When the job was done and I later went to change out all the fixtures/fans, they had left every fixture in place, so there was a large patch of popcorn and unpainted ceiling left behind - it just didn't dawn on me to specify that they take those down before scraping and painting. It was kind of a mess.
As the peak industry body for the painting and decorating industry in NSW, MPA has been since its foundation over 100 years ago, an independent representative for firms and individuals conducting business in the painting, decorating and sign writing trades. We do this by our involvement with numerous government consultative forums both nationally and at a state level.
If you're going to do any part of the painting or prep work on your own, you must know that the first step in preparing a surface is washing it. Since dirt can affect the smoothness of a surface area -- and therefore paint's adhesion to it -- use soap to remove any dirt or stains. Make sure there's no soap left on the walls when you're finished; also make sure to remove any gloss with sandpaper and vacuum up the leftover dust.
90% of the homes we service generally have some degree of siding decay or rot. We specialize in tearing-out & repairing the sub-structure and replacing the siding. Through our repair experience we are able to not only properly install new siding but also proactively stop future issues by employing advanced sealing and preparation techniques learned through our years of siding specialization. Click on Figure 1 for an explanation of what you will find after the rotted siding is removed.
Day-to-day tasks can consume too much time when there is little or no automation. Countless cloud-based productivity tools are available to streamline and automate your tasks. These tools can usually be put into place with little disruption to your current practices. Ultimately, integrating new automation tools will increase productivity and help you make the most […]
Disclaimer: NerdWallet strives to keep its information accurate and up to date. This information may be different than what you see when you visit a financial institution, service provider or specific product’s site. All financial products, shopping products and services are presented without warranty. When evaluating offers, please review the financial institution’s Terms and Conditions. Pre-qualified offers are not binding. If you find discrepancies with your credit score or information from your credit report, please contact TransUnion® directly.
Only a dummy gets involved with so-called "contractors." Hire a qualified actual worker yourself. Check out their resume/background, etc. RULE #1..NO ADVANCE DEPOSITS! Pay daily or weekly or upon satisfied completion according your standard, not workers. Contractors are merely employment agents. If that's the way you get work done, then go ahead and waste your money and wind up with the myriad of problems enumerated upon in the news clip above. RULE#2.. NO SMOKERS. They are lighting up on your money. RULE#3: No cell phones while working. Talk on their own time after work